Wear a dust mask and goggles when cutting or sanding wood.
Wear gloves when working with wood.
Some preservative may migrate from the treated wood into soil/water
or may dislodge from the treated wood surface upon contact with skin.
Wash exposed skin areas thoroughly.
All sawdust and construction debris should be cleaned up and
disposed of after construction.
Wash work clothes separately from other household clothing
before re-use.
Preserved wood should not be used where it may come into direct
contact or indirect contact with drinking water, except for uses
involving incidental contact such as fresh water docks and bridges.
Do not use preserved wood under circumstances where the
preservative may become a component of food, animal feed, or beehives.
Do not use preserved wood for mulch.
Only preserved wood that is visibly clean and free of surface residue
should be used.
Do not use preserved wood in direct contact with aluminium.
If wood is to be used in an interior application and becomes wet
during construction, it should be allowed to dry before being covered
or enclosed.
Disposal Recommendations: Preserved wood may be disposed of in landfills or burned in commercial or industrial incinerators or boilers in accordance with National and Regional regulations.
If you desire to apply a paint, stain, clear water repellent or other
finish to your preserved wood, we recommend following the
manufacturer’s instructions and label of the finishing product.
Before you start, we recommend that you apply the finishing product
to a small test area before finishing the entire project to ensure that
it provides the intended result.
Certain metal products (including fasteners, hardware and flashing)
may corrode when in direct contact with wood treated with copper
based preservatives. To prevent premature corrosion and failure it is
important to follow the recommendations of the manufacturer for
all metal products.
Mould growth can and does occur on the surface of many products,
including treated or untreated wood, during prolonged surface
exposure to excessive moisture conditions. To remove mould from
treated wood surfaces, wood should be allowed to dry. Typically,
mild soap and water can be used to remove surface mould.